Factory Setting; Programming The Remote Control - Becker Centronic SunWindControl SWC441-II Notice De Montage Et D'utilisation

Sun threshold value: Intermediate position (25KLux)
Wind threshold value: Left limit stop (2 m/s) Intermediate position
Programming the remote control
Caution
Before programming the transmitter, please check whether the thresh-
old control switches are set to the factory setting. When programming
the transmitter, ensure that you are not located in the operating area of
the sun protection system.
1) Learning the master transmitter
a) Put receiver into learn mode
Note
The master transmitter is the very first transmitter programmed on a
receiver. In contrast to subsequently programmed transmitters, the
master transmitter enables, among other things, the setting of limit po-
sitions (for drives with integr. radio receiver) and the programming or
deleting of further transmitters.Any transmitter which has a separate
UP, STOP, DOWN button and a programming button can be a master
transmitter.
Always follow the installation and operating instructions of the receiver.
Use a suitable cylindrical tool (e. g. ball-point pen) to actuate the pro-
gramming button on the transmitter.
• Switch off the receiver's power supply and reconnect after 5 seconds.
or
• Actuate the programming button or the radio-controlled receiver switch.
The receiver will then be in "Learn" mode for 3 minutes.
Factory setting
de
en
fr
nl
19