Test Mode - Becker Centronic SunWindControl SWC441-II Notice De Montage Et D'utilisation

Masquer les pouces Voir aussi pour Centronic SunWindControl SWC441-II:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Assembly and Operating Instructions
Wind threshold control switch
Becker sensor)
This control switch allows you to set the wind threshold values (approx. 2m/s
to 22 m/s).
The wind threshold value can be set to 11 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: retract when wind speed is low
+ Right limit stop = Level 11: retract when wind speed is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value. If the wind speed rises above the preset wind threshold, the sun
protection system is retracted and remains closed. The sun protection
system is extended again if the wind speed remains below the preset
wind threshold for approx. 15 minutes.
Sun threshold control switch
Becker sensor)
This control switch allows you to set the sun threshold values (approx. 5KLux
to 100KLux).
The sun threshold value can be set to 15 different levels. If you turn the control
switch slowly, the tubular drive makes a clacking sound for each level.
- Left limit stop = Level 1: extend when sun intensity is low
+ Right limit stop = Level 15: extend when sun intensity is high
If the threshold values are changed, these are adopted immediately.
Note
Please ensure that no buttons are pressed when setting the threshold
value. If the sun intensity rises above the preset sun threshold, the sun
protection system is extended with a time delay of up to 5 minutes. The
sun protection system is retracted again automatically if the sun inten-
sity remains below the sun threshold for approx. 15 minutes.
TEST mode
The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the slid-
ing switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are
reduced.
18
(in combination with a suitable
(in combination with a suitable

Publicité

Table des Matières
loading

Table des Matières