Standard Accessories; Applications - HIKOKI D10VC3 Mode D'emploi

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
D10VC3 : Drill
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
V Rated voltage
P Power input
n
No-load speed
0
Switching ON
Switching OFF
Lock
Switch locks to the "ON" position.
Change rotation speed - High speed
Change rotation speed - Low speed
Disconnect mains plug from electrical outlet
Class II tool
SPECIFICATIONS
Voltage (by areas)*
Power input
No load speed
Drill chuck capacity
Steel
Capacity
Wood
Weight (without cord)
Spec. for keyed chuck
Spec. for keyless chuck
* Be sure to check the nameplate on product as it is subject to change by areas.
Twist Bit
Flat Spade Bit
Auger Bit

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed in the below.
(1) Chuck wrench (Spec. only for keyed chuck) ................1
Standard accessories are subject to change without notice.

APPLICATIONS

Drilling in metal, lumber and plastics.
(110 V, 220 V, 230 V, 240 V)
600 W*
0 – 2500 min
10 mm
10 mm
32 mm
25 mm
1.4 kg
1.4 kg
4
–1