Manual Time Setting - Sangean RCR-1 Mode D'emploi

Manual time setting

TIME
Press TIME button, display will flash and previous allocated time.
Press SET button, the Hour digits in the time display begin to blink
with a beep.
GB
1. Adjust the hour with key + or - .
2. Press the SET button once again to confirm the hour, now the
minute digits in the time display begin to blink.
Adjust the minutes just as you adjusted the hour:
1. Set the minutes with key + or - .
2. Press the TIME button once again to confirm the time setting with
a beep.
The analog clock movement begins to turn and stop at right time
position, the second starts to count. The symbol will appear
indicating this is not radio controlled time.
Note:
If there is Daylight Saving Time (D.S.T.) system in your place,
after pressing SET button, press Mode button once will
advance one hour on time setting, Display will show D.S.T.
symbol indicating the time is under D.S.T. status.
8