Sangean RCR-1 Mode D'emploi page 14

Cancel alarm setting
If you do not wish to be woken up at the alarm time you have set, you
can cancel the alarm function.
1. Select alarm system 1 or 2 by pressing the alarm 1 or 2 button
(key 15 or 14).
2. Press SET button, the alarm mode symbol will blink with a beep.
3. Press alarm MODE button 20 one or two times (depending you
were in alarm radio or alarm buzzer status) till display blink
4. Press alarm 1 or 2 button again to confirm alarm cancellation.
The symbol will stay on the display for around 2 seconds and
disappear.
Note:
You may also select days of the week which you wish to be or not to
be woken after pressing SET button while display is blinking days of
the week. Press 1-7 (Sunday – Saturday) of button 19 for selection.
Snooze
To interrupt the alarm signal ( radio or beep tone/HWS), press the
Snooze button 18. The alarm stops and begins again with interval of
5 minutes. The alarm will continue for an hour if not being interrupted.
Stop the alarm signal
To stop the alarm signal totally, press button 1 Power on/off.
13
.