Sangean RCR-1 Mode D'emploi page 8

Clock
Radio controlled clock
In normal case, please set the time zone switch 10 to 0 position.
After ATS completes, display will appear — : — and the symbol
will blink indicating the radio is searching radio controlled signal. The
correct time and date will be set automatically. When the time signal
is being received , the time and date have been set correctly
( after approximate 3 minutes ) , the symbol stops blinking and
remains lit indicating the time and date are with radio controlled time
. The analog clock movement will automatically activate to the right
position.
If the symbol blinks irregularly, try to improve the reception of the
radio controlled time signal by re-allocating the radio. If the time
signal can not be received in your area, you will have to set the time
and date manually.
Note:
To activate radio controlled time check manually, press Time button
13 for more than 4 seconds, the appliance will start to search radio
controlled time signal.
7