Electrical Connection; Cleaning; Storage; Maintenance - Parkside Pasa 550 A1 Instructions De Fonctionnement Et De Sécurité

11.2 Emptying the dust bag (11) (Fig. 1)
Danger of injury!
Danger due to wood dust
The inhalation of wood dust is hazardous to health! Always
wear a dust protection mask when emptying the dust bag.
When disposing of the dust waste, ensure that it is disposed of
in an environmentally friendly manner!
1. Switch the product off at least 10 minutes before empty-
ing the dust bag (11) so that the dust particles can settle.
2. Then disconnect the product from the power supply.
3. Empty the dust bag (11) if it is 60-70% full.

12. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer's mains connection as well as the exten-
sion cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often dam-
aged.
This may have the following causes:
• Pressure points, where connection cables are passed
through windows or doors.
• Kinks where the connection cable has been improperly
fastened or routed.
• Places where the connection cables have been cut due to
being driven over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not be used
and are life-threatening due to the insulation damage.
Check the electrical connection cables for damage regularly.
Ensure that the connection cables are disconnected from elec-
trical power when checking for damage.
Electrical connection cables must comply with the applicable
VDE and DIN provisions. Only use connection cables of the
same designation.
The printing of the type designation on the connection cable
is mandatory.
For single-phase AC motors, we recommend a fuse rating of C
16A or K 16A for machines with a high starting current (from
3000 watts)!
8 GB/IE/NI/CY/MT
Connection type Y
If it is necessary to replace the mains connection cable, this
must be done by the manufacturer or their representative to
avoid safety hazards.

13. Cleaning

m Attention!
Disconnect the mains plug before carrying out any cleaning
work.
• Keep protective devices, air vents and the motor housing
as free of dust and dirt as possible. Rub the product clean
with a clean cloth or blow it off with compressed air at
low pressure. We recommend that you clean the product
directly after every use.
• Clean the product at regular intervals using a damp cloth
and a little soft soap. Do not use any cleaning products or
solvents; they could attack the plastic parts of the product.
Make sure that no water can penetrate the product interior.
• Make sure that no water can penetrate the interior of the
product.

14. Storage

Store the product and its accessories in a dark, dry and frost-
free place that is inaccessible to children.
The optimum storage temperature lies between 5 and 30 ˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture. Store the
operating manual with the product.
Risk of damage!
If the product is not stored properly, the engine can be dam-
aged.
• Store the product protected against dirt, dust and moisture.
• Store the product in its original packaging.
• Cover the product to protect it from dust or moisture.
• Store the operating manual with the product.

15. Maintenance

Attention!
Disconnect the mains plug before carrying out any mainte-
nance work.
Check all safety devices after maintenance or cleaning work
and put them back into operation.