Carrying Handle - Ridgid R48607B Manuel De L'opérateur

FEATURES
DEPTH
KNOW YOUR COMPOUND MITER SAW
CONTROL KNOB
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
DEPTH
STOP
7-1/4 in. BLADE
BEVEL
A 7-1/4 in. blade is included with the compound miter saw.
STOP PIN
It will cut materials up to 1-1/2 in. thick or 7-1/4 in. wide,
depending upon the angle at which the cut is being made.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. Loosen the bevel lock knob to
release the saw allowing the blade to be tilted either left or
right for bevel cuts. Tighten the knob to lock the saw in place.
NOTE: To obtain right bevel angles, loosen the bevel knob
and release pressure on the pin by tilting the saw to the left,
then pull the bevel stop pin out and tilt the saw to the desired
BEVEL STOP ADJUSTMENT
angle. Push the bevel stop pin in for a positive 0° bevel stop.
SCREW FOR 45 ANGLES
°
BEVEL STOP ADJUSTMENT SCREWS
33.9º
See Figure 2.
Bevel stop adjustment screws have been provided on each
side of the saw arm. These adjustment screws are for mak-
ing fine adjustments at 0°, 33.9°, 45° and 48°.
NOTE: Use the bevel stop turrets to locate 33.9°, 45°, and
48º
45º
48° bevel angles. When making any non-bevel cut, the bevel
stop turrets should be in the 48° position. The maximum
BEVEL STOP
bevel cut that can be made on the right side is 45°. TURRET
Fig. 2
BLADE WRENCH STORAGE
A blade wrench is packed with the saw. One end of the
wrench is a Phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the Phillips end when removing or loosening screws. A
storage area for the blade wrench is located in the carrying
handle on the top of the saw.

CARRYING HANDLE

See Figure 3.
Carrying handles are located on the top of the saw arm and
on the sides of the saw base. To transport, turn the saw off
and remove the battery pack, then lower saw arm and lock
it in the down position; lock bevel and miter lock levers; lock
slide lock knob.
DEPTH CONTROL KNOB
See Figure 2.
The depth control knob is a guide for limiting downward
movement of the saw arm.
NOTE: Controlling depth of cut is necessary when rough
cutting a dado.
9 - English