Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
s
:
peCifiCations
A.
Input Voltage
B.
Daily Water Production
C.
Tank Size
D.
Temperature of Water
E.
Max. TDS
F.
RO Membrane Rejection
G.
Treatment Stages
t
C
apping into
CAUTION:
Step 1 Turn off the cold water supply by turning off the shut off valve under the sink. If the cold water line
does not have a shut off valve under the sink, turn off the main water line in the house.
Step 2 Turn on the cold water faucet and allow all the water to drain from the line. On a single handle
faucet, the hot water may have to be turned off to prevent any hot water cross over.
Step 3 Loosen nut and separate cold water braided flex line from the Kitchen Cold Water Faucet Shank.
Attach the slip joint adapter to the kitchen cold water faucet shank using the rubber washer supplied
in the kit. Reinstall the flex line onto the slip joint adapter and tighten. Use Teflon tape on all
threaded connection points.
Step 4 Attach the ball valve to the slip joint adapter. Use Teflon tape on all threaded connection points.
Step 5 White 1/4" tubing is attached to needle valve and tighten with compression nut.
w
l
old
ateR
ine
The water supply to your unit MUST be from the COLD WATER LINE.
Hot water will severely damage your RO System.
AC120V - DC24V (VRO-5WP only)
50 GPD/189L
3.2 U.S. Gal/12.0L
5 - 45˚ Celsius
1000 ppm
92 - 99%
1, 2, 3, 4 and 5 stage
:
Kitchen cold water faucet shank
Rubber Washer
Needle Valve – Use Teflon tape on all threads
1/4" Compression nut
Slip Joint Adapter- Use Teflon tape on thread
connecting to kitchen faucet cold water shank
Flex line to inlet water supply - use Teflon Tape on all
connection points
7
Publicité
Chapitres
Table des Matières
