vitapur VRO-3 Guide D'installation, Utilisation Et D'entretien page 11

i
nstallation of
To Bypass the Air Gap Faucet
A 3/8" to 1/4" quick connect fitting is supplied if you want to by pass the air gap connection on the faucet.
In this case the 1/4" black drain tubing connects to one end of the quick connect and the 3/8" black tubing
connects to the other end of the quick connect. The 3/8" line then goes to the saddle drain clamp connection.
Some provinces/states have a requirement for connection of drain line to air gap faucet.
3/8" Side of Connector
CAUTION: The installation of this system must be in accordance with all provincial/state and/or local
laws and regulations regarding plumbing and electrical. Please consult regulations concerning
the air gap connection on RO faucets in your province or state.
RO Product Water Connection
Step 3 Loosen stem-nut on the faucet.
Step 4 Slide Chrome plate and black rubber washer onto the faucet stem. The chrome plate, large rubber
faucet washer and faucet body are above sink or countertop.
Step 5 Feed the 3/8" and 1/4" black tubing through the pre-drilled hole in the sink/counter.
Step 6 Place the faucet through the drilled faucet hole and add spacer, securing plate, star lock washer and
stem nut.
Step 7 Tighten stem nut firmly while aligning faucet in the desired location.
Step 8 Attach quick connect to stem of air gap faucet.
Step 9 The 3/8 blue tubing is attached to the quick connect (product water) from RO unit.
p w
RoduCt
Chrome Plate
Rubber Washer
Counter top
f :
ateR auCet
9
1/4" Side of Connector
Counter top
Spacer
Securing Plate
L ock Washer
¼" Nut
Quick connect for
RO to faucet
Blue Line
3 / "
8
Product Water