Mounting The Ro Unit Under The Sink - vitapur VRO-3 Guide D'installation, Utilisation Et D'entretien

m
ounting tHe
Step 1 Locate the RO unit on the back or right wall under the sink. Make sure to allow ample space
for the installation and plumbing connections. To change the filter cartridges, a minimum of 4 "
of clearance is required underneath the filter housings. A minimum of 4 inches of clearance
from the left bracket mounting screw hole.
Step 2 Install mounting screws at least 17 1/8" inches from cabinet floor. Leave 5/16 inch space between the head
of the screw and the wall to slip bracket onto the screws.
The spacing between the mounting holes is as follows:
VRO-3 : 7 1/8"
VRO-4 : 6"
Model: VRO-3
4"
13 1/2"
4" Minimum Clearance
m
ounting tHe
CAUTION:
Step 1. Connect the ball valve to the water storage tank thread on the upper side of the tank. Make sure it is
tight but not over tight.
Step 2. Connect the yellow 3/8" tubing to the tank ball valve. Push the tubing in all the way to make sure it is
properly seated. This is a quick connect.
Step 3. Turn the tank ball valve off.
Ro u u
nit ndeR tHe
VRO-5 : 11 1/4"
VRO-5WP : 12 1/8"
4"
13 1/2"
4" Minimum Clearance
t b v
ank all alve
Do not tamper with the air valve on the storage tank. It has been preset
and screwed on with black cap by the manufacturer.
Ball Valve
OFF
s :
ink
Model: VRO-4
o t :
nto ank
12
Models VRO-5 and VRO-5WP
4"
13 1/2"
4" Minimum Clearance
Ball Valve
ON