Inline Post Carbon Filter Replacement - vitapur VRO-3 Guide D'installation, Utilisation Et D'entretien

i p C
nline ost aRbon
The inline post carbon filter has a life expectancy between 6 to 12 months. The inline post carbon filter
is an effective filter in removing any post odor and taste.
Step 1 Turn off the incoming water supply to the RO by turning the needle valve on the slip joint
connection clockwise until it stops.
Step 2 Close the tank valve on top of the holding tank.
Step 3 Open the RO faucet for 10 seconds. This will release the pressure in the RO system.
blue plug
3/8" blue
tubing
Removing the Old Inline Post Carbon Filter from the Reverse Osmosis Unit
Step 1 Remove the blue horseshoe securing the 3/8" blue tubing in the quick connect on the old inline
post carbon filter. Then disconnect the 3/8" blue tubing by pushing in the collet and pulling out the
3/8" blue tubing.
Step 2 Remove the blue horseshoe securing the 3/8" yellow tubing in the quick connect on the old inline
post carbon filter. Then disconnect the 3/8" yellow tubing by pushing in the collet and pulling out
the 3/8" yellow tubing.
Step 3 Remove the blue horseshoe securing the 1/4" white tubing in the quick connect on the old inline
post carbon filter. Then disconnect the 1/4" white tubing by pushing in the collet and pulling out
the ¼" white tubing.
Connecting the Replacement Inline Post Carbon Filter
Step 1 Place the replacement inline post carbon filter onto the two plastic holders which are on the RO
membrane housing. Remove the blue horseshoe securing the blue plug on the new inline post
carbon filter. Remove the blue plug by pushing in the collet and pulling out the blue plug. Connect
the 3/8" blue tubing back into the new inline carbon filter. Place the blue horseshoe back to secure
the blue tubing.
Step 2 Remove the blue horseshoe securing the yellow plug on the replacement inline post carbon filter.
Remove the yellow plug by pushing in the collet and pulling out the blue plug. Connect the 3/8"
yellow tubing back into the inline carbon filter. Place the blue horseshoe back to secure the
yellow tubing.
Step 3 Remove the blue horseshoe securing the white plug on the replacement inline post carbon filter.
Remove the white plug by pushing in the collet and pulling out the blue plug. Connect the
1/4" white tubing back into the inline carbon filter. Place the blue horseshoe back to secure
the white tubing.
Step 4 Follow the Start-Up instructions on page 14.
f R
ilteR eplaCement
blue horseshoe
collet
Inline post carbon filter
RO membrane housing
(vRo-4, vRo-5 & vRo-5wp
1/4" white
tubing
18
only
blue horseshoe
white plug
collet
collet
3/8" yellow
tubing
)
yellow plug