Installing The Membrane Into The Membrane Housing - vitapur VRO-3 Guide D'installation, Utilisation Et D'entretien

i
nstallation of
Step 1 Attach the drain clamp to the vertical section of the drain pipe, about 6 inches above the trap. Make
sure the opening on the drain clamp is facing towards the drinking water faucet.
Step 2 Using the fittings hole of the drain clamp as a guide, drill a ¼" hole through one side of the
drainpipe.
Step 3 Remove the drain clamp from the drainpipe and enlarge the hole with a ½" drill bit. Use a file to
remove rough edges from the drilled hole.
Step 4 Make sure the black rubber gasket is adhered to the inside of the drain clamp and place the drain
clamp assembly over the drilled hole. Look through the hole and position the clamp so that the center
of the clamp hole is slightly higher (1/16") than the center of the drilled hole. Tighten the clamp
securely.
Step 5 Connect 3/8" black tube to saddle clamp quick connect.
Drain Clamp
Front Plat e
Quick connect
Black Line
/ "
3
8
Drain Tubing
i
nstalling tHe
Step 1 Cleans hands before removing the plastic packaging from the RO membrane
Step 2 Remove the tube connection from the RO membrane cap.
Step 3 Loosen the cap by using the wrench provided in a counterclockwise direction.
Step 4 Lubricate the O-rings on the new membrane with water. Insert the end with the two black O-rings
first into the housing.
Step 5 Once the membrane has been inserted into the housing give a firm push to properly seat the
membrane.
Step 6 Check to see that the O-ring is in the cap properly seated. Replace membrane housing cap and
tighten with the supplied wrench in the clockwise direction.
Membrane Housing
s d
addle Rain
1/4" Bolt
Drain Pipe
m
embRane into tHe
C :
lamp
1/4" Nut
Drain Clamp
Back Plate
m
embRane
2 Rubber
O-Rings
This end inserted
into housing rst
10
Never
Mount
Here
H :
ousing
2 Rubber
O-Rings
Tighten Housing Cap by
Turning Wrench Clockwise
Mount Drain
Valve Here
Wrench