Troubleshooting - Parkside Pbts 370 B2 Instructions De Fonctionnement Et De Sécurité

16. Troubleshooting

Fault Possible cause
Motor does not start On/off switch damaged
On/off cable damaged
On/off relay damaged
Machine becomes slower Too much pressure is applied to the
during work. workpiece.
Sanding belt comes off It does not run straight.
the drive pulleys.
Wood gets burnt during Sanding disc or belt is covered with
sanding. grease.
Excessive pressure was applied to
the workpiece.
10 GB/IE/NI/CY/MT
Remedy
Replace all damaged parts before you use your sander again.
Contact your local service centre or an authorised service station.
Every attempt to carry out a repair, can be dangerous if it is not
done by skilled personnel.
Apply less pressure to the workpiece.
Reset the track.
Replace belt or disc.
Reduce the pressure applied to the workpiece.