CDVI TERENA Manuel D'installation page 16

INSTALLATION MANUAL
TERENA - TERENA16
Web Based Access Control
LOCAL PORT
G
If you are accessing the TERENA via a server,
don't forget to enter the address of the local port
to enable communication.
H SUBNET MASK
Limits which devices can connect to TERENA.
Default value 255.255.255.0
PUBLIC PORT
I
J DEFAULT GATEWAY
If you are connecting to the TERENA using a router,
enter the router IP address. Default value 0.0.0.0
DATE & TIME
K
Select the date and time.
L REMOTE ADMINISTRATION
To be able to control the TERENA system from a
remote site, select "YES". Then enter a specific IP
Address that will allow access to the controller.
M APPLY THE SETTINGS
Applies the configuration on TERENA controller.
RESET CONTROLLER
N
To perform a reset controller, click on the icon
RESET CONTROLLER. This will set the factory default
values on the controller.
When all the configuration of the controller have been set then restart
the tereNa controller to save all new settings. Click on the restart icon.
cdvi.com
16
cdvigroup.com
INTERFACE OPTION
A B C
A CONFIGURATION
Ethernet connection setup and data
initialisation.
B READERS
Allows you to adjust reader settings
in the event of a fault.
C DATA RESTORATION
Restores data using the backup file
(see page 14).
D UPDATE
This option allows you to update the system
using the update package we supply
(see page 14).
MAINTENANCE
E
By clicking on the Maintenance icon, TERENA
prepares to shut down to enable maintenance
operations and thus avoid loss of data during
the intervention.
F RESTART
Reboots the system.
EXIT
G
Allows you to exit the TERENA interface.
EN
D E F G