Important Electrical Information; Parts List - Earlex SPRAY STATION HV3500 Mode D'emploi

Masquer les pouces Voir aussi pour SPRAY STATION HV3500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY OPERATING INSTRUCTIONS
WARNING! FIRE AND EXPLOSION HAZARD.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
G
OR INJURY, DO NOT EXPOSE TO RAIN; STORE INDOORS.
The materials used with this spray gun (paint, thinners etc) may
G
contain hazardous, harmful, explosive or corrosive materials. ALWAYS
COMPLY WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS
PRODUCT AND THE MATERIAL BEING USED.
The spray gun must be used only with paints and solvents that have a
G
suitable flash point for spraying. If in doubt, consult the paint or solvent
manufacturer's data.
Always ensure there is adequate ventilation when spraying.
G
NEVER spray near an open flame, including an appliance pilot flame.
G
NEVER smoke when spraying.
G
Always disconnect the unit from the electrical outlet when cleaning the
G
spray applicator.
Always ensure the spray area is safe and free from all debris that may
G
present a fire or fall hazard.
NEVER, under any circumstances, point the spray gun at another
G
person or animal. In the event of an injury, seek immediate medical
attention.

IMPORTANT ELECTRICAL INFORMATION

EXTENSION CORDS
Your HVLP Spray Station is supplied with a power cord that is 6 feet long. Make sure your power cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current your product will utilize. For lengths up to 50 feet, No 18 AWG extension cords should be
used.
DOUBLE INSULATED APPLIANCE
This Spray Station is a double insulated appliance and, as such, does not require three-way grounding. This product is
equipped with a polarized alternating current line plug (a plug having one blade wider than the other) and does not
require a grounding adapter. This plug will fit into the power outlet only one way.If you are unable to insert the plug fully
into the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician for further details. Do
not defeat the safety purpose of the polarized plug.

PARTS LIST

Fig.1
No.Description
1. Needle and Fluid Tip Tool
2. Air Cap Ring
3. Air Cap
4. Spray Pattern Adjustor
5. Fluid Tip
6. Fluid Tip O-Ring
7. Fluid Needle
IMPORTANT: SELECTING PAINT
Your Spray Station can be used with a wide variety of paints, stains and coatings such as latex, deck and fence stain, sealers, varnishes, wood
preservatives, enamels, oil and water-based paints and automotive paints.
However, some materials cannot be sprayed so please check the recommendation of the manufacturer before buying the paint. If a material refers to
brush application only then it usually cannot be sprayed.
THIS UNIT CANNOT BE USED FOR TEXTURED PAINTS. USE OF THESE MATERIALS WILL CAUSE PREMATURE WEAR, WHICH WILL VOID
YOUR WARRANTY. TO OBTAIN THE BEST RESULTS FROM YOUR SPRAY STATION, PLEASE READ THE INSTRUCTIONS CAREFULLY
BEFORE USE.
NEVER allow children or unauthorized users to operate or play with
G
the spray equipment.
Always read the paint manufacturer's thinning instructions before use.
G
Always wear the correct protective face mask when spraying. We also
G
recommend wearing gloves, goggles and overalls.
You must clean the spray gun thoroughly after each use.
G
Use only genuine manufacturer replacement parts.
G
Use the spray equipment only as detailed in these instructions.
G
Do not use the air hose or power cord to move the Spray Station unit.
G
Check the hoses, hose connectors and power cord frequently. Any
G
worn or damaged parts should be replaced immediately.
This Spray Station is recommended for household use only.
G
This Spray Station is not intended for use by persons (including
G
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Part Code
No.Description
V0018
8. Lip Seal - Fluid Needle
V0001
9. Paint Flow Adjuster
V0002
10. Paint Container Seal
V0003
11. Pick-up Tube
V0004
12. Paint Container
V0005
13. Hose
V0006
14. Filter
4
MAINS
SWITCH
SHOWN IN
OFF POSI-
TION
Part Code
V0007
V0011
L0682
V0012
V0014
L1064
L0058

Publicité

Table des Matières
loading

Table des Matières