Safety Information; Initial Start-Up; Cleaning/Maintenance; General Cleaning Work - Parkside Pass 5 A1 Traduction Des Instructions Originales

Safety information

Also observe the safety instruction
for your high-pressure washer.
• Be aware of the increased risk of trip-
ping when using your pressure washer
with the suction hose.
• Do not run over, squash or crease the
suction hose. There is a risk of damage
and therefore injury to you.
• Use only original accessories and do
not carry out conversion work on the
equipment.
• Store the equipment in a frost-proof
room.

Initial start-up

1. If necessary, fix the filter basket with
backflow stop (4) to the suction hose
(2) using the coupling nut (3).
2. Place the filter basket with backflow
stop (4) in the water source.
3. Connect the suction hose (2) to the
water connection, coupling on the pres-
sure washer, using the Quick connector
with garden hose adapter (1).
Caution: Do not allow the
pressure washer to run dry!
Danger of overheating!

Cleaning/maintenance

Always remove the mains plug of
the pressure washer before work-
ing. Danger of electric shock.

General cleaning work

• Clean the filter basket (4) regularly us-
ing clear water to remove dirt.
Disposal/environmental
protection
The device, accessories and packaging
should be properly recycled.

Accessories

Spare parts and accessories can be
obtained at
www.grizzly-service.eu
If you have issues ordering, please use the
contact form.
If you have any other questions, contact
the "Service-Center" (see page 11).
GB IE
9