Important - Ge Gldt696D00Ss Instructions D’installation

Installation Instructions
STEP 13 - CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8".3/4'or 1"
diameter connections on the air gap, waste tee or
disposer . Cut on the marked line as required for your
installation.
Cutting Lines
My
NA N24 N 4
Figure 20
IMPORTANT:Do not cut corrugated
portion of hose
elf a longer drain hose is required,add up to 42"off length
for a total of 10ft. to the factory installed hose.
Use 5/8"or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection with
hose clamps.
Hose Clamp
Coupler
Hose Clamp Figure 21
*Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
*Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1- Air gap with waste tee or disposer
ae LU ve EB
Waste Tee Installation Disposer Installation
Figure 22
Method 2- High drain loop with waste tee or disposer
Fasten to underside
A of countertop
Fasten to underside
LA of countertop
Waste Tee Installation Disposer Installation
Figure 23
IMPORTANT -
When connecting drain line to Remove
disposer , check to be sure that hopper
drain plug has been removed. plug
DISHWASHER WILL NOT DRAIN
IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call char ges. Always
be sure disposer drain plug has been removed before
attaching dishwasher crain hose to the disposer .
10