Wall Bracket Option; Preparations For Security Lock; Mounting - Fronius Acctiva Smart 25 A Instructions De Service

Wall bracket op- Different wall plugs and screws will be required depending on the supporting surface. Wall
tion plugs and screws are therefore not included in the scope of supply. The installer is respon-
sible for selecting the right wall plugs and screws.
Preparations for
security lock

Mounting

Danger due to improper installation of the charger in a switch cabinet (or in a similar
enclosed space).
This can result in damage to property.
► Ensure sufficient heat dissipation using forced-air ventilation.
► There should be a clearance of 10 cm (3.94 in.) all around the device.
The space requirement dimensions in mm (inches) illustrated below are given to ensure
that there is easy access to the plug connections:
60
"click"
NOTE!
"click"
The security lock is not contained in the
scope of supply.
A security lock can only be attached
- to the groove on the housing as shown
- to the groove on the housing that is ex-
actly opposite
- using spacer M8 DIN 125 or DIN 134,
located as shown