Ego Power+ SNT2807 Manuel De L'opérateur page 18

INSTALLING THE SNOW-
DISCHARGE CHUTE ASSEMBLY
(Fig. 3)
WARNING:
snow blower without the complete
snow-discharge chute in place.
NOTICE:
Check and make sure the
electrical cable is not overstretched.
Overstretching may lead to electrical
cable damage resulting in loss of control
over the chute by the electronic chute
direction/pitch control handle.
1. Lift the snow-discharge chute assembly
and align the outer support pole with
the inner support pole (Fig. 3a).
2. Slide the outer support pole down
until the snow-discharge chute is fully
seated on the base.
3. Secure the snow-discharge chute
assembly with two knobs and bolts
(Fig. 3b).
18
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2800/SNT2800-FC
Never operate the
3a
Snow-
Discharge
Chute
Inner
Support
Pole
Base
3b
Knobs & Bolts
Outer Support Pole
Electrical
Cable