Adding Detergent - Zanussi ZDT26022FA Notice D'utilisation

ADDING DETERGENT

If the programme has a prewash phase, put a small quantity of detergent also in compartment B.
ADDING MULTI-TABLETS
• Adjust the water softener to the lowest level.
SETTING AND STARTING A PROGRAMME
The AUTO OFF function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has not
started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance is in
programme selection mode.
3. Press one of the programme buttons until the
display shows the number of the desired
programme. The display shows the programme
duration after some seconds.
4. Set the applicable options.
5. Close the appliance door to start the
programme.
Option Delay
1. Set a programme.
2. Press until the display shows the delay time
you want to set (1-24h).
1
2
1
2
A
B
The delay time flashes in the display.
3. Close the appliance door. The countdown
starts to decrease by 1 hour.
When the countdown is complete the programme
starts.
Option XtraDry
Activate this option to boost the drying
performance. With XtraDry on, the duration of some
programmes, water consumption and the last rinse
temperature can be affected.
XtraDry is a permanent option for all programmes
other than Eco and need not to be selected at
every cycle.
In the other programmes the setting of XtraDry is
permanent and it is automatically used in next
cycles. This configuration can be changed at any
time
This option is not available with Rinse and Hold.
Option TimeManager
This option increases the pressure and the
temperature of the water. The washing and the
drying phases are shorter.
The total programme duration decreases by
approximately 50%.
The washing results are the same as with the
normal programme duration. The drying results can
decrease.
27