Training Of Personnel; Maintenance; Customer Service / Support; De-Commissioning - ABNOX AXDV-C1 Instructions De Service

Training of Personnel

Only trained and instructed personnel who have read
and understood all points of the Operating Manual
may work on the product. Likewise the individual
operating states must be mastered, and the related
safe aspects must be known and they must be able
to implement them. Personnel undergoing training
may only work on the product under the supervision
of qualified personnel.

Maintenance

The indicated maintenance intervals are based on
single-shift operation. Depending on the use site,
medium and cases of multi-shift operation, main-
tenance may need to be performed more frequently.
WHEN WHAT
Weekly Check
dosing valve
for tightness
Weekly Check all
screw and
armature
connections
for tightness
Monthly Check seals
for damage
and wear
Annually Complete
service
CAUTION
All work on the plant absolutely
must be done when it is idle. The
pneumatic and hydraulic systems
must be de-pressurised. The
manometers must show 0 bar.
HOW WHO
optically Operator's
technicians
optically Operator's
technicians
optically Operator's
technicians
Disas- Operator's
semble, technicians
clean and
replace
seals

Customer Service / Support

ABNOX AG
Langackerstrasse 25
CH-6330 Cham
Switzerland
Tel. +41 (0) 41 780 44 55
Fax +41 (0) 41 780 44 50
E-Mail info@abnox.com
Internet www.abnox.com

De-Commissioning

Brief Interruptions:
In the event of short interruptions (overnight or just
over the weekend), shut down the product. The
system must be de-pressurised.
Long-Term Interruptions:
In the event of a longer-term interruption (more than
three days), the following points should be observed:
• The main switch must be shut down
• The system must be de-pressurised (check the
displays)
CAUTION
Risk of accident and danger to the
environment:
Grease / oil on the ground increase
the risk of accident.
The grease/oil must be properly
disposed of in compliance with
applicable national ordinances
(hazardous waste).

Drawings and Replacement Parts

Accessories, drawings, dimensioning sheets, data
sheets and replacement parts can be found at
www.abnox.com.

Idling and Disposal

When de-commissioning/idling the product, please
heed the following points:
• Switch off the main switch (if any)
• Unplug the main power plug from the main supply
(if any)
• The system must be depressurised.
• The medium must be removed and properly
disposed of.
EN
21