Festo HSW-10 Série Notice D'utilisation page 56

HSW−...−AP/A S
Replacing the shock absorbers:
1. Exhaust the drive.
2. Remove the protective cover.
3. Remove the proximity switch and the
sensor rail on the shock absorber holder
(only in HSW−12/16−...).
4. Loosen the locking nut (A)
(only in HSW−10−...).
5. Unscrew the old shock absorber (B)
(in HSW−12/16−... with the stop sleeve; a
spanner flat is available on the thread of
the shock absorber).
6. Screw the new shock absorber in again
(for tightening torque see table).
7. Tighten the locking nut (only in
HSW−10−...; for tightening torque see
table).
8. Fasten the sensor rail
(only in HSW−12/16−...).
9. Push the proximity switch into the
groove of the sensor rail.
10. Fasten the proximity switch in the end
position.
11. Fasten the protective cover.
Permissible tightening torque [Nm]
Locking nut (HSW−10−...)
Shock absorber with stop sleeve
(HSW−12/16−...)
Fig. 35
Reduce the amount of waste by using the materials in the shock absorber for
S
other purposes (material recycling).
The shock absorber is filled with hydraulic oil.
56
HSW−10−...
HSW−12/16−...
Fig. 34
HSW−10−... HSW−12−...
(YSRWF−4−6) (YSRW−5−8)
0.5 Nm 0.5 Nm
Festo HSW−...−AP/AS 0707a English
(A)
(B)
(B)
HSW−16−...
(YSRW−7−10)
1 Nm