Starting And Stopping - QEP 83250Q Manuel D'utilisation

DAMAGED OR MISSING, DO NOT ATTEMPT
TO OPERATE THIS SAW. OPERATING THIS
SAW WITH DAMAGED OR MISSING PARTS
COULD RESULT IN POSSIBLE SERIOUS
PERSONAL INJURY.

StartinG and StOPPinG

1 . Connect the unit to a power supply of the
correct voltage and frequency (120V-60HZ) .
2 . To start the saw press the switch to the
"ON" position (Fig 4) .
3 . To stop the saw, press the switch to the
"OFF" position (Fig 4)
SAFETY, ALWAYS POSITION THE SWITCH
TO THE "OFF" POSITION WHEN THE SAW
IS NOT IN USE. IN THE EVENT OF A POWER
FAILURE, BLOWN FUSE OR TRIPPED CIRCUIT
BREAkER, PRESS SWITCH TO THE "OFF"
POSITION. THIS WILL PREVENT THE TOOL
FROM STARTING UP AGAIN WHEN THE
POWER COMES BACk ON .
figure 4
1 . Clean the working area .
2 . Remove saw from carton, you will find
it assembled .
3 . Lay the saw on its side on the ground (Fig 5) .
figure 5
IF ANY PARTS ARE
FOR YOUR OWN
figure 5-1
4 . Pull out the stand legs (Fig 5-1) .
5 . Stand the saw upright .
figure 5-2
6 . Tighten thumb screw to secure legs (Fig
5-2) .
figure 6
7 . Micro adjustment for perfect level . (Fig . 6)
– 6 –