QEP 83250Q Manuel D'utilisation page 13

5 . From underneath the saw, directly below the rip
fence, there are two ¼" bolts located under the
left rip fence and 2 bolts under the right rip
fence . Loosen both bolts for the rip fence that
you are adjusting . (See Images E & F)
image e
¼
" bolts
image f
6 . Once the screws are loose, easily slide the
rip fence above, allowing you to close the
gap between the square and the rip fence .
When the square is flush against the rip
fence re-tighten the two ¼" bolts from the
side you are adjusting . If necessary, repeat
the same steps for the other side . (See
Image G)
image g
7 . Once both rip fences are secured in place
slide the extruded aluminum angle bar firmly
against both rip fences and tighten in place
for additional support .
Q.e.P. CUStOmer SerViCe:
1-866-435-8665
– 11 –