QEP 83250Q Manuel D'utilisation page 9

8 . To mount the handle on the trolley and
secure it using the 2 screws (Fig 7) .
figure 7
9 . The motor trolley is secured during
shipment, please loosen lever before using
(Fig 8) .
figure 8
FiLLinG tHe Water tray
and draininG
1 . Fill the tray with water between minimum
and maximum water line . Do not add
chemicals or detergents to the water .
2 . To drain, remove the plug from the inside of
the tray, the water will flow out or you can
remove the tray and pour the water out
The tray can also be filled with the hose
attached under the water tray with a
gentle flow .
OPERATION
CONTINUOUS RIM BLADES WITH THIS SAW.
DO NOT USE SEGMENTED, "TURBO" BLADES,
WOOD SAWING BLADES, BLADES WITH
OPENINGS, OR ANY OTHER CUTTING DEVICES
WITH THIS TILE SAW. USING THESE BLADES
USE ONLY
COULD RESULT IN SERIOUS PERSONAL
INJURY AND DAMAGE TO THE SAW.
maKinG a StraiGHt CUt
1 . Push the motor trolley away from the
operator until it reaches the stroke limit .
2 . Position the tile on the cutting table .
3 . Properly set the measuring guide and
squaring tool (Fig 9) .
figure 9
4 . Pull the motor trolley slowly towards the
material to be cut (Fig 10) .
figure 10
5 . When you have completed the cut push
motor trolley/blade away and remove the
cut pieces, and any debris on cutting
surfaces .
– 7 –