QEP 83250Q Manuel D'utilisation page 12

WHat tO dO WHen tHe aLiGnment
iS OFF On tHe BridGe SaW:
The QEP # 83250Q 30" Bridge Saw motor or
bridge does not need to be squared up or aligned,
since the bridge does not allow the saw motor to
move . When it appears that the saw is out of
alignment, it is the rip fence that needs to be
squared up .
Tools needed:
24" Framing Square, Phillips Screw Driver and
¼" Nut Driver or Pliers
The following steps should be used to align the
rip fence for the Bridge Saw:
1 . Pull the power unit towards you and lock in
place with the transport lever .
2 . Once the power unit is secured, place the
Framing square firmly against the blade on the
left side of the cutting surface . The square
must be flush with the blade . (See Image A) .
image a
3 . Slide the square into the rip fence, making
sure the square stays firmly against the
blade . Look for a gap between the square and
the rip fence . If there is a gap, adjustments
will be necessary . (See Image B)
gap
rip
Fence
image b
4 . To adjust the gap, first remove the Angle cutting
guide . This will expose two screws in the
aluminum track . Loosen both screws in the
extruded aluminum bar . (See Image C & D)
image c
Left
Rip Fence
image d
– 10 –
Right
Rip Fence