Electric Brake - Makita 5402NA Manuel D'instruction

Sighting
B
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the
B position with it.
Switch action
► 1. Lock-off button 2. Switch trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, push in the lock-off button and pull the
switch trigger. Release the switch trigger to stop.

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
ASSEMBLY
•
A
Removing or installing saw blade
1
► 1. Shaft lock 2. Hex wrench
•
2
•
Release the lock lever of blade steady device.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
1 2
► 1. Hex bolt 2. Outer flange 3. Inner flange 4. Saw
After installing the blade, lock the lock lever.
When changing blade, make sure to also clean the
upper and lower blade guards of accumulated sawdust
as discussed in the Maintenance section. Such efforts
do not replace the need to check lower guard operation
before each use.
7 ENGLISH
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
2
CAUTION:
Be sure the blade is installed with teeth pointing
up at the front of the tool.
Use only the Makita wrench to install or remove
the blade.
blade
1
3
4