Reading Out Measurement Data - TESTO 175 Mode D'emploi

7 Using the product

7.6. Reading out measurement data

The measurement data remain stored in the data
logger after they have been read out and can
therefore be read out several times. The
measurement data will only be deleted when the
data logger is reprogrammed.
Via USB cable
1. Connect the USB cable to a free USB port on the PC.
2. Loosen the screw on the right side of the data logger.
Use a coin for this purpose.
3. Open the cover.
4. Plug the USB cable into the Mini USB port (1).
5. Read out the data logger and process the read out
data, see separate operating instructions testo
ComSoft.
Via SD card
1. Loosen the screw on the right side of the data logger.
Use a coin for this purpose.
2. Open the cover.
3. Push the SD card into the SD card slot (2).
-
The display shows
175 T2, testo 175 T3, testo 175 H1).
52
Sd (testo 175 T1) or Sd CArd (testo