Connecting The Data Logger To Pc - TESTO 175 Mode D'emploi

4. Insert the batteries (type AAA). Observe the polarity!
5. Place the battery compartment cover on the battery
compartment.
6. Tighten the screws.
- The display shows rST.
Pos: 28 /TD/Erste Schritte/testo 175/Datenlogger an PC anschließen Hardware @ 6\mod_1275476329286_79.doc @ 62373 @

5.3. Connecting the data logger to PC

For testo ComSoft 5 Basic:
The software is available in the Internet as a free download
requiring registration: www.testo.com/download-center.
The instructions for the installation and operation of
the software can be found in the testo ComSoft 5
Basic instruction manual, which can be downloaded
together with the software.
The software can be ordered on CD (article-no:
0572 0580), if the download from the Internet is not
desired.
For testo ComSoft Professional und testo ComSoft CFR:
> Insert the CD into the CD-ROM drive.
1. Install the software testo ComSoft.
2. Connect the USB cable to a free USB port on the PC.
3. Loosen the screw on the right side of the data logger.
4. Open the cover.
5. Plug the USB cable into the Mini USB port (1).
6. Configure the data logger, see separate operating
instructions testo ComSoft.
5 First steps
41