Water Filter Replacement (If Applicable); Celsius And Fahrenheit Selection - Bertazzoni Rfd90S5Fpns/24 Manuel D'utilisation Et De Maintenance

DISPLAY PANEL SET-UP INSTRUCTIONS
WATER FILTER REPLACEMENT (IF
APPLICABLE)
The water filter symbol on the user interface flashes and
beeps to advise the user to replace the water filter. The
water filter is located inside a plastic casing positioned in
the top left corner of the refrigerator compartment.
• To access the filter, press on the central clip of the
casing. The bottom part of the casing will open by
rotating it 45° downwards.
• To remove the filter, gently pull it down from the rear of
the cartridge to allow for a better grip when removing,
then firmly hold the base and rotate the filter body
counterclockwise. Then, gently pull it out.
• To install the new filter, firmly hold the base and insert
the replacement filter, then secure it by rotating it
clockwise. Push the rear of the cartridge back upwards
until it is level. Finally, close the filter casing by rotating
the bottom part 45° upwards, ensuring it snaps onto the
central clip.
After the replacement is complete, reset the filter counter
by pressing and holding the SELECT button for 5 seconds.
Failing to reset the filter counter will put the water dispenser
and ice maker in standby mode, preventing them from
dispensing water and ice. The set replacement time is 130
days.
The refrigerator comes equipped with a water plug
designed to replace the water filter when connected to a
centralized water treatment system or when the filter is not
used. If your refrigerator is connected to such a system,
remove the filter and install the water plug in its place within
the filter casing.
After 130 days of use, an alarm on the user interface will
remind to reset the filter counter, even when using the
water plug.
NOTE
Failure to reset the filter counter will cause
the water dispenser and ice maker to enter
standby mode and cease to function.

CELSIUS AND FAHRENHEIT SELECTION

To switch between Celsius and Fahrenheit, press the
MENU button until the Celsius and Fahrenheit selection
symbol lights up. Press the SELECT button to confirm your
choice.
11