Water Filter Replacement (If Applicable) - Bertazzoni Ref31Bmfixnv Manuel D'installation, D'utilisation Et De Maintenance

DISPLAY PANEL SET-UP INSTRUCTIONS
WATER FILTER REPLACEMENT (IF
APPLICABLE)
It is suggested to change the water filter every 6 months to
ensure the best possible water quality. Filters may be
purchased at Encompass Parts (https:// encompass. com/)
under the SKU Z320380. After installing, check the
installation thoroughly for leaks.
1) Shut off water supply.
2) Remove clips from each end of the old water filter.
3) Press down on collar at one end of the filter and pull the
tube out of the filter.
4) Repeat Step 3 on the other end of the filter.
5) Note the Flow direction on the filter.
1
1) Water supply inlet
2) Filtered water
6) Insert water supply tube into the inlet side of the filter
until the tube stops.
2
7) Repeat Step 6 on the outlet side of the filter.
8) After inserting tube, re-install the clip between the collar
and the filter, making sure it is secure. The clip will
secure the tube to the filter.
Fig. 41
9) Turn on the water and check for leaks. If leaks occur,
repeat Step 1 through 8. If leaks persist, discontinue use
and call your supporting dealer.
10) Flush filter for 5 minutes before use.
NOTE
The warranty does not cover any parts,
labor, or damage to property caused by
improper installation, use, maintenance,
repair or service.
NOTE
You must also ensure that the cut is
square and not at any sort of angle as
this could cause a leak.
Fig. 42
Fig. 43
29