Door Bins; Glass Shelves - Bertazzoni Rfd90S5Fpns/24 Manuel D'utilisation Et De Maintenance

OPERATING THE APPLIANCE

DOOR BINS

To remove a door bin, hold it from the bottom, lift it and slide
it out. Please see the figure.
To adjust the height of a door bin, press and hold the
buttons at the right and left sides to adjust the bin to the
desired height without having to remove it. To remove the
adjustable door bin, press and hold the buttons, lift the bin
completely and pull it towards yourself. To reinstall the door
bin, position it in its place on the door and press the buttons
to slide it downwards. Please see the figure.

GLASS SHELVES

The height of the glass shelves can be adjusted manually
using the rear hangers. Holding a shelf from the bottom, lift
the front part and raise it to an angled position; the tabs on
the hangers will be released and the glass shelf will move
up and down.
To remove a shelf
• Hold the front of the shelf, then gently lift up and slide it
out.
To reinsert
• Hold the shelf at an angle so that the front is higher than
the back, then insert the top hook into the top shelf notch
you wish to use.
• Lower the front gently.
NOTE
Fig. 4
To prevent breakage or scratching the
interior of the fridge, use care when
handling glass shelves.
WARNING
Glass shelves must be unloaded before
moving.
Fig. 5
WARNING
You must wait for the glass shelves to
reach room temperature before immersing
them in water for cleaning.
WARNING
The door may not close if the door bins are
positioned at the same level as the glass
shelves. After placing the shelves, make
sure that the door can close properly.
Fig. 6
15