Tesla RB5210FHXE Mode D'emploi page 17

TROUBLESHOOTING
CAUTION!
Before troubleshooting, disconnect the power supply. Only a qualified electrician of competent person
must do the troubleshooting that is not in this manual.
IMPORTANT! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes or cools too
much
The food is not frozen enough.
Heavy build up of frost on the
door seal.
Unusual noises
Side panels are hot
If the malfunction shows again, contact the Service Center. These data are necessary to help you quickly
and correctly. Write the necessary data here, refer to the rating plate.
Possible cause
Power plug is not plugged in or
is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or
the appliance runs at SUPER
modes.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Door seal is not air tight.
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
It's normal. Heat exchange is in
the side panels.
17
Solution
Insert power plug.
Check fuse, replace if necessary.
Socket malfunctions are to be
corrected by an electrician.
Turn the temperature regulator
to a warmer setting temporarily.
Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (on a cool setting).
At the same time shape the
warmed door seal by hand such
that it sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
Take gloves to touch side panels
if need.
ENG