Mounting System Installation; Optional Installation - GE GX1S50R Manuel D'utilisation Et D'installation

INSTALL THE FAUCET
6. Feed the water tube up through the faucet base.
Then push the tube into the fitting on the bottom
of the faucet body. It should go in about 3/4".
Pull tube slightly to make sure it is secure.
Faucet Body
Base
Toggle Screw
7. Push the faucet body down into the faucet base
and twist clockwise until it clicks into place.
NOTE: You can install the faucet so the handle
is on the right or the left side.
If you want the faucet handle on the right,
position the handle at the back of the faucet
base before turning clockwise.
If you want the faucet handle on the left,
position the handle at the front of the faucet
base before turning clockwise.
Faucet
Faucet handle on the RIGHT
8. Locate the hole at the rear of the base. Insert
set screw and begin to tighten by hand. Finish
tightening with the Allen wrench provided
in the packet.
Installation Instructions
(CONT.)
Gasket
Sink
Faucet
Faucet handle on the LEFT

MOUNTING SYSTEM INSTALLATION

Pick a location under the sink to mount the system.
Location should be easily accessible, with at least 5
inches of clearance between the bottom of the filter
canister and the floor or bottom of the cabinet; any
less will result in difficulty of removing filter canister.
Allow enough space on either side of the system for
the tubing connections.
A. PREFERRED INSTALLATION
(Mounting Using the Screw Provided [Fig. 4])
1. Remove shrink wrap from filter system.
2. System should be mounted to a stud in the wall
or solid firm surface.
3. Use the screw (B) provided to mount through the
screw hole in the center of the manifold (A). (Pre-drill
a 1/16" pilot hole, if needed). NOTE: If mounting to
drywall, with no stud, a drywall anchor (not
included) must be used.
(A) Manifold
B. OPTIONAL INSTALLATION
(Mounting Using the Mounting Tape Provided [Fig. 5])
(If mounting to drywall, the screw must be used also).
1. Remove shrink wrap from filter system.
2. Clean wall surface to remove any dirt, oil or grease
and dry thoroughly.
3. Using the double-sided mounting tape provided (C),
remove one side of the protective wax paper and
apply the entire piece to the back side of the
manifold (A), applying firm pressure to the entire
piece.
4. Remove the remaining wax paper from the
double-sided mounting tape (C) and adhere it to
the cleaned wall surface, applying firm pressure
to the entire piece.
(C) Mounting tape
7
(B) Screw
Fig. 4
(A) Manifold
Fig. 5