EINHELL TC-LD 60 R Instructions D'origine page 16

measurement
→ The result is displayed at the bottom in m
6.6 Deleting values (Fig. 3 / Item 4)
To delete any wrongly measured values again,
press button C briefly. You can then perform the
measurement again.
6.7 Memory (Fig. 3 / Item 4 D, E, C)
The last 20 measured values are automatically
saved in the memory. To enter the memory, press
button D (+) or E (-). You can also use these but-
tons to search the memory. To delete the saved
values, press button C.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before start-
ing any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished us-
ing it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use clean-
ing agents or solvents; these could
attack the plastic parts of the equipment.
Ensure that no water can seep into the de-
vice. The ingress of water into an electric tool
increases the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
GB
7.3 Ordering spare parts and accessories
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offices.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pack-
aging.
- 16 -
Tip! For good results we rec-
ommend high-quality acces-
sories from !
www.kwb.eu
welcome@kwb.eu