shark SKWAL JET Manuel D'utilisation page 20

REMOVING THE CHEEK PADS
1 - Open the main visor.
2 - Turn the helmet over and undo
each cheek pad, one after the other.
Un-clip each cheek pad from each of
its 3 fixing slots in the following order:
the rear end, then the middle, and
finally the front. Pull into the helmet.
4 - Completely remove each of the
cheek pads from the inside by sliding
them onto each end of the chinstrap
while turning the helmet over if
necessary.
20
20
20
1
2
3 - Turn the helmet over again to more
easily undo two front snap fasteners,
one side velcro fastener and one rear
snap fastener on each cheek pad.
Hold the two velcro surfaces on either
side in place as much as possible in
order to gently loosen the area (A).
3
4