Delta R2707 Mode D'emploi page 8

E.
F.
1
Solder connections.
D.
Turn on water supplies and check for leaks.
E.
Finish surface up to cardboard spacers (1). Washer (2) indicates maximum
F.
finished deck thickness.
Loosen screws (1) until washer (2) is free. Rotate washer 90° and remove.
G.
Cut cardboard tubes (3) flush to finished deck and-discard.
G.
H.
I.
Replace washers (1) on end valves and spout adapter. Rotate 90° to
H.
expose screws (2).
Tighten screws (1) with a regular slotted screwdriver. Tighten until
I.
washers (2) are flush to the finished deck surface. NOTE: Gradually
tighten all six screws (1) together to prevent binding. You are now
ready for the trim kit. Please see the trim installation instructions.