Hazet 4903/4 Mode D'emploi page 27

When doing this, hold the strut together with the head plate/spring plate down in a central position
on the Universal Clamping Disc 4903-2.
Move the Grippers form A
that neither the head plate nor the spring plate can twist or slip out and secure it.
Determine ? mm
Gripper form A
? 140-294 mm
3
Design and function
against the head plate/spring plate. Align the grippers
3
4
r
e
If the diameter of the head plate or the spring
plate is smaller than the clamping range of Gripper
form A, please use Gripper form B.
w
Gripper form B
? 70-150 mm
To change the grippers, loosen screw
Grippers form A and replace them with the Grippers
form B. Move the Grippers form B
head plate. Adjust the required distance
side lays with screw
e
in such a way
3
, remove the
4
against the
3
w
to secure the spring strut.
r
of the
27