Bosch Kiox BUI330 Notice D'utilisation D'origine page 12

English – 10​
Colour of Explanation
the indica-
tor d
will be provided for the bike lights and
the on-board computer. The remaining
capacity of the eBike battery is enough
for about 2 hours of lighting. This does
not account for other consumers (e.g.
eShift gear changing, charging external
devices using the USB port) which
could reduce the duration.
If the eBike battery is being charged on the wheel, a
corresponding notification will be displayed.
If the on-board computer is removed from the holder
(5), the state of charge that was last displayed for the
battery is saved.
Setting the assistance level
On the operating unit (7), you can set the level of as-
sistance you want the eBike drive to provide you with
while pedalling. The assistance level can be changed
at any time, even while cycling.
Note: In some models, the assistance level may be
preset and cannot be changed. There may also be
fewer assistance levels available than stated here.
If the manufacturer has configured the eBike with
eMTB Mode, the assistance level SPORT is replaced
by eMTB. In eMTB Mode, the assistance factor and
torque are dynamically adjusted according to the
force you exert on the pedals. eMTB Mode is only
available for Performance Line CX drives.
The following assistance levels are available as a max-
imum:
– OFF: Motor assistance is switched off. The eBike
can just be moved by pedaling, as with a normal bi-
cycle. The push assistance cannot be activated at
this assistance level.
– ECO: Effective assistance with maximum efficiency,
for maximum range
– TOUR: Steady assistance, long range for touring
1 270 U20 XBK | (21.06.2018)
– SPORT/eMTB:
SPORT: Powerful assistance, for mountain biking
and for cycling in urban traffic
eMTB: Optimum assistance whatever the terrain,
rapid acceleration when starting from a standstill,
improved dynamics and top performance
– TURBO: Maximum assistance even at high pedaling
speeds, for biking sports
To increase the assistance level, press the + (12)
button on the operating unit repeatedly until the de-
sired assistance level appears on the display. To de-
crease the assistance level, press the – (11) button.
The requested motor output appears on the display
h. The maximum motor output depends on the se-
lected assistance level.
If the on-board computer is removed from the holder
(5), the assistance level that was last displayed for
the battery is saved.
Switching the push assistance on/off
The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7 mph.
The lower the selected gear, the lower the speed of
the push assistance function (at full power).
The push assistance function must only be used
u
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance function, briefly press
button (13) on your on-board computer. After activa-
tion, press button + within 3 s and keep it pressed.
The eBike drive is switched on.
The push assistance is switched off as soon as one of
the following occurs:
– You release the + button;
– The wheels of the eBike are locked (e.g. by applying
the brakes or hitting an obstacle);
– The speed exceeds 3.7 mph.
After releasing the + button, the push assistance re-
mains on standby for another three seconds. If you
Bosch eBike Systems