Before You Start - Urbanglide Ride 55 Notice Originale

When unpacking, please check the contents against the packing list.
WARNING: Before mounting the scooter, please make sure the power switch is in the "OFF"
ESTIMATED TIME FOR ASSEMBLY
In general, the assembly can be completed in 25 minutes, not counting the charging time for the first time.
The first time, the charging time is 7 hours.
Mounting the handlebar
WARNING: The scooter must always be switched off while charging.

BEFORE YOU START

Throttle button
1.
Power switch
2.
Brake pedal
3.
Charging support
4.
Tools needed
1 open key of 12—14mm (not
included with the scooter)
1 open key 13—15mm (not
included with scooter)
ASSEMBLY
Referring to Figure 1, align the steering T-bar and push it over the fork
tube. Make sure the four holes are properly aligned with each other.
(The throttle button on the handle should be on the right side once
installed.)
Insert a round flat-headed hex nut and bolt into the keyhole, as shown in
the drawing, and tighten them using two 4mm hexagonal wrenches.
2 hexagonal keys of 4mm
(supplied with the
scooter)
1 x 4mm socket hex wrench
(not included with the
scooter)
6
position.
1 screwdriver (not included
with the scooter)