URBANGLIDE RIDE 55 Notice Originale page 24

REAR WHEEL REPLACEMENT
Tools needed: 1 screwdriver, 1 wrench open from 12 to 14 mm and 1 wrench open from 13 to 15 mm.
Loosen the locking screws on
the engine cover using a
Philips screwdriver and
remove the cover.
REAR WHEEL REPLACEMENT
Mount the entire
replacement rear wheel on
the frame by inserting it
into the rear wheel axle
slot in the opposite
direction of the procedure
described in step 2 above.
SERVICES AND SERVICES
Loosen the fixing screws
with a Philips screwdriver
make sure that all these parts are in the correct position when reassembling.
Make sure the back axle
is in place at the back of
the frame. Then tighten
the motor fixing screws
using a Philips
screwdriver.
Remove the nut from the
rear wheel axle with a 13
mm and 14 mm flat wrench.
Pay close attention to the location of the parts on the rear wheel and
Tighten the rear wheel
shaft nut with a 13 and 14
mm wrench and check
that the wheel can rotate
freely.
9
Mount the engine cover
with a screwdriver. Do
nottighten the screws
too much, otherwise you
may damage the engine
cover.