Repair And Services - Urbanglide Ride 55 Notice Originale

Masquer les pouces Voir aussi pour RIDE 55:

Table des Matières

Les langues disponibles

FRONT WHEEL REPLACEMENT

Remove the axle from

the front wheel by

turning

counterclockwise and

using 2 x 5 mm hex

wrenches.

Do not store the battery in an environment where the temperature is above 25ºC or below 0ºC.

This scooter contains sealed lead-acid batteries, which must be recycled in accordance with the laws and regulations in force in

your locality. Please read and understand the following instructions regarding battery disposal.

Disposal: This product contains sealed lead-acid batteries, which must be disposed of in an environmentally responsible manner.

Do not throw a lead-acid battery into the tire. The battery may explode or leak. Do not dispose of lead-acid batteries in household

waste. Incineration, burial or mixing sealed lead-acid batteries with household waste is prohibited by law in most areas. Return end-

of-life batteries to an authorized lead-acid recycler or local automotive battery dealer.

Charger: The charger that comes with the scooter should be examined regularly for any damage to the cord, plug, case, and other

parts. In case of damage, the scooter should not be charged until the charger has been repaired or replaced.

Wheels: wear and tear is inevitable on the wheels and driving system during use. This is not a defect of the product. The user must

regularly check the wear of the wheels and the driving system and make the necessary adjustments or replacements.

CAUTION: In case of battery leakage, avoid contact with leaking acid and place the damaged battery in a plastic bag. Refer to the

removal instructions above. If the acid comes into contact with skin or eyes, wash in cold water for at least 15 minutes and consult

a doctor.

Pay close attention to the

location of the parts on the

front wheel and make sure

that all these parts are in the

correct position when

reassembling. (The front

wheel is removed in the

same way as the rear

wheel.)

REPAIR AND SERVICES

Tighten the axis of the front

wheel by turning clockwise

with 2 x 5mm hexagonal

keys.

Table des Matières