Before Your Start; Assembly - URBANGLIDE 55 Manuel D'utilisation

Upon unpacking, please check the contents against the packing list.
WARNING: Before assembling the scooter, please make sure power switch is turned
'OFF'.
ESTIMATED TIME FOR ASSEMBLY
Assembly can typically be completed in 25
Time of charging is 7 hours for the first time.
Assembling the steering handle
WARNING: The scooter must always be switched off while being charged.

BEFORE YOUR START

minutes, not including the time of
Throttle knob
1.
Power switch
2.
Brake pedal
3.
Charging socket
4.
Required Tools
1pc 12—14mm open
spanner (Not provided
along with scooter)
1pc 13—15mm open
spanner (Not provided
along with scooter)

ASSEMBLY

According to the figure 1, align the steering T-bar and push it onto the fork tube.
Ensure all four hales are aligned with each other. (The throttle knob on the handle
shall be on the right hand side when installed.)
insert a hexagon round flat head nut and bolt into the lock hole, as indicated in the
drawing, and tighten them using two 4mm hex keys
charging for the first time.
2pcs 4mm hex keys
(Provided along with
the scooter)
1pc 4mm socket hexagon
spanner (Not provided
along with the scooter
1 pc screw driver (Not
provided along with the
scooter)
4