Next Level Racing ES1 HAPTIC Manuel D'instructions page 13

public health that are caused by improper disposal of electronic waste. The recycling of materials
contributes to the conservation of natural resources. Do not dispose of your old electrical and
electronic equipment with the unsorted municipal waste.5.1.2 Disposal of packaging waste
5.1.2 Disposal of packaging waste
The packaging is made of environmentally friendly materials where possible, which may be
disposed through your local recycling facilities. By disposing of the packaging and packaging waste
in the proper manner, you help to avoid possible hazards for the environment and public health. The
symbol on the packaging indicates that the packaging is made of PAP.
6 INSTALL ES1 HAPTIC TO NEXT LEVEL RACING COCKPITS
6.1 NLR ELITE Cockpit Series Assembly for Side Mounting
(Universal Seat Brackets required for GT ELITE LITE)
NOTE: Attach your seat to a cockpit before using. Follow instructions below to attach onto Next Level Racing Cockpits. Once the seat is
installed to cockpit go to page 22, section 7 for operating instructions.
WARNING: Steps following ES1 Haptic Seat assembly, show typical ES1 Haptic seat assembly to cockpit frames. These steps
do not show cable management. Please take caution of cable management and ensure cables do not get pinched with
seat & frame assembly. Do not place cables on or over seat sliders.
01
Check internal Seat Brackets width 500mm.
02
Confirm fit of Seat with position of Seat Brackets.
13
PARTS:
• • NIL
PARTS:
• • 1 x ES1 Haptic Seat