Dell PowerEdge R470 Manuel D'installation Et De Maintenance page 183

8. Disconnect the cables routing from the left side wall bracket and middle cable bracket from their connectors on the HPM board.
REMARQUE : See
Étapes
1. Using the Phillips 2 screwdriver, loosen the thumb screw on the OCP NIC cage.
2. Pull and slide the OCP NIC cage out from the front of the system.
REMARQUE : Les numéros figurant sur l'image ne représentent pas les étapes exactes. Les nombres permettent d'indiquer la
séquence.
Figure 206. Removing an OCP NIC cage from front of the system
3. If the OCP NIC cage is not being replaced, install a filler tray into the system and secure it by tightening the captive screw using a
Phillips 2 screwdriver.
Figure 207. Installing an OCP NIC card filler bracket
cable routing section for more information.
Désassemblage et réassemblage 183