Kenwood KDC-X720 Mode D'emploi page 26

BLUETOOTH®
Connect with a remote device by One-touch (NFC)
(for /
Near Field Communication (NFC) enables short-range wireless
communication between the unit and remote devices such as
smartphones.
By holding an NFC-compatible remote device near to the N-Mark on
the unit (right side of the panel), the unit and remote device proceed
to complete pairing and established the BLUETOOTH connection
automatically.
1 Activate the NFC function on the remote device.
Refer to the instruction manual of the remote device for more
information.
2
Hold the remote device near to the N-Mark on the unit (right side of
the panel).
The device vibrates when pairing is completed.
• Depending on the type of remote device used, the strength of the NFC
signal may vary. For a stronger NFC signal, user must understand the
position of the remote device's NFC antenna and hence tap the NFC
antenna with the NFC logo.
• To disconnect, hold the remote device near to the N-Mark on the unit
again.
• This unit only can recognize and connect to one NFC-compatible device
at a time.
22
ENGLISH
/ )
BLUETOOTH — Mobile phone
Receive a call
When there is an incoming call:
• The KEY zone illuminates in green color and flashes.
• The unit answers the call automatically if [AUTO ANSWER] is set to a
selected time. ( 24)
During a call:
• The LCD DISPLAY zone illuminates according to the settings made for
[DISPLAY] ( 32) and the KEY zone illuminates in green color.
• If you turn off the unit or detach the faceplate, the Bluetooth
connection is disconnected.
The following operations may differ or not available depending on the
connected phone.
To On the faceplate
First incoming call...
Answer a call
Press
volume knob or one of
the number buttons
(1 to 6).
Reject a call
Press
End a call
Press
KEY
On the remote control
or the Press .
Press .
.
Press .
.