Features; Operating Instructions; Sanding; Switching On-Off (Fig. 4) - Powerplus Powdp50400 Mode D'emploi

9 FEATURES

Your eccentric sander is equipped with TPR soft grip and protective parts. TPR (Thermoplastic
rubber) is elastic, chock absorbing and environmental friendly (recyclable).

10 OPERATING INSTRUCTIONS

Before attempting to use your sander be sure to familiarize yourself with all its operating
features and safety requirements.
Warning! The battery should always be removed from the machine when
assembling parts, marking adjustments, cleaning or when the tool is not in
use. Disconnecting the battery will prevent accidental starting that could
cause serious injury.
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ...).
10.1

Sanding

▪
Hold the sander in front and away from you, keeping it clear of the work piece.
▪
Start the sander.
▪
Let the motor build up to speed then gradually lower it on to the work with a slight forward
movement.
▪
Move the sander slowly over the work piece using forward and back or side to side
strokes.
▪
Upon completion of the sanding operation remove the sander from the work piece before
turning it off.
10.2

Switching On-off (Fig. 4)

Connect the battery pack (5) to the power tool by pushing the release button (6). The tool is
switched "On" by the ON/OFF switch (2) located on top of the tool housing.
▪ Switch on: push the ON/OFF switch button (2) to the "I" position.
▪ Switch off: push the ON/OFF switch button (2) to the "O" position.
10.3

Attaching the sandpaper

Attaching self-adhesive sandpaper (Fig. 5).
▪ Select a sandpaper with the appropriate grit size for the task.
▪ Position the sandpaper so that its holes are aligned with those on the sanding pad (3).
▪ Press the sandpaper onto the sanding pad (3) and check it is secure.
▪ To remove the sanding paper carefully peel the sanding paper away from the sanding
pad (3).
WARNING: When removing the sanding paper, follow the above procedure
in reverse order.
WARNING: Before making any adjustments ensure the machine is switched
off or remove the battery pack.
Copyright © 2021 VARO
POWDP50400
P a g e | 8
EN
www.varo.com