Safety Instructions; Care And Cleaning - AEG SWS74500G0 Manuel D'utilisation

4 www.aeg.com
• if the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.

2. SAFETy INSTRUCTIONS

2.1 Installation
Warning! Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Always be careful when you move the appli-
ance because it is heavy. Always wear safety
gloves.
• Make sure the air can circulate around the
appliance.
• Wait at least 4 hours before connec ting the
appliance to the power supply. This is to al-
low the oil to flow back in the compressor.
• Do not install the appliance close to radia-
tors or cookers, oven or hobs.
the appliance must stand against the wall.
• Do not install the appliance where there is
direct sunlight.
• Do not install this appliance in areas that
are too humid or too colds, such as the
construction appendices, garages or wine
cellars.
• When you move the appliance, lift it by the
front edge to avoid scratching the floor.
2.2 Electrical connection
Warning! Risk of fire and electrical shock.
• The appliance must be earthed.
• All electrical connections should be made
by a qualified electrician.
• Make sure that the electrical information on
the rating plate agrees with the power sup-
ply. if not contact an electrician.
• Always use a correctly installed shockproof
socket.
• Do not use multi-plug adapters and exten-
sion cables.
• Make sure not to cause damage to the elec-
trical components (e.g. mains plug, mains
cable, compressor). Contact the Service
or an elect rician to change the electrical
components.
• The mains cable must stay below the level of
the mains plug.
• Connect the mains plug to the mains socket
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
2.3 Use
• Do not change the specification of this
appliance.
• Do not put electrical appliances (e.g. ice
cream makers) in the appliance unless they
are stated applicable by the manufacturer.
• Be careful not to cause damage to the
The rear of
refrigerant circuit. it contains isobutane
(R600a), a natural gas with a high level of
environmental compatibility. This gas is
flammable.
• if damage occurs to the refrigerant circuit,
make sure that there are no flames and
sources of ignition in the room. Ventilate
the room.
• Do not let hot items to touch the plastic
parts of the appliance.
• Do not store flammable gas and liquid in the
appliance.
• Do not put flammable products or items
that are wet with flammable products in,
near or on the appliance.
• Do not touch the compressor or the con-
denser. They are hot.

2.4 Care and cleaning

• Before maintenance, deactivate the appli-
ance and disconnect the mains plug from
the mains socket.
• This appliance contains hydrocarbons in the
cooling unit. Only a qualified person must
do the maintenance and the recharging of
the unit.
• Regularly examine the drain of the appli-
ance and if necessary, clean it. if the drain
is blocked, defrosted water collects in the
bottom of the appliance.
Warning! Risk of fire and electrical shock
or fire.
Warning! RRisk of injury or damage to
the appliance.