Installations - Panasonic Gp-Rv700 Mode D'emploi

INSTALLATIONS

I. Remove the Mounting
removing the four monitor fixing screws.
2. Place the mounting
installed in the vehicle,
(procured locally ø6 mm).
3. Place the monitor onto the bracket and tighten with the
four monitor fixing screws.
4. Install the GP-Q48 monitor hood (option) by tightening
the two screws supplied, if required.
6
Bracket from the monitor by
Remove screws
bracket on the position to
and secure it with the four bolts
c
5. Connect the remote
connector on the
The remote cable is designated
below.
be
To Rearview Monitor
O +12 V DC (red)
@ Remote tn (blue)
@ Not Used
@ Ground (green)
@ Audio In (white)
@ Video In (yellow)
O Ground (green)
@ Camera Ground (black)
@ +9 V DC (red)
To Rearview Camera
O Audio In (white)
@ Video In (yellow)
O Camera Ground (black)
@ +9 V DC (red)
cable to the REMOTE/CAMERA
rear of the monitor.
as shown in the figure
Connect
Remote
Cable